2003 - 2009 Toyota 4Runner Angled Sliders **NO KICK OUT**HREW / Powder CoatedHREW / Bare MetalDOM / Powder CoatedDOM / Bare Metal

Vendor: RSG METALWORKS
Type:
Price: 775.00 - 1099.00 (4 variants)

For the ultimate rocker panel solution, RSG Offroad is proud to offer their bulletproof  4th Gen (2003 - 2009) Toyota 4Runner Angled Sliders with NO KICK OUT

These fit Xreas and KDSS vehicles after Xreas and KDSS has been removed!

- 2" Main tube for increased strength

- 1/4" Mounting plates 

- 4 leg design, stronger than most competitors products

- 12* Angle for maximum clearance (Some trim models require the rear door to be trimmed to clear slider frame)

- Capable of supporting the entire side of the vehicle for lifting with hi-lift jack

- Bolts to factory mounting locations on the frame with supplied hardware

- Approximately 125 # per set 

- Available bare metal or powder coated 

- Fitment: 2003-2009 4Runner 

*Also fits 03-09 GX470, however it will require removing the factory steps / trim below the body pinch seam

 Install notes for these sliders can be seen on the install notes page.

Order your set today!